How To Set Time On Acurite Indoor Outdoor Thermometer

ACURITE Wireless Indoor/Outdoor Thermometer Instructions

Battery Installation
Batteries not incuded
Insert 2 fresh alkaline "AAA" batteries into the main unit first, then the remote unit of measurement side by side. Practice not mix old and new batteries. Practice not mix alkali metal, standard (carbonzinc), or rechargeable (nickelcadmium) batteries.
Slide off the battery compartment cover on the back of each unit of measurement. Be sure to insert the batteries in the correct manner according to the polarity symbols indicated in the battery compartment. After the batteries are installed in the main unit, "IN" will display the main unit of measurement temperature. The "OUT" temperature volition display "" due to the remote unit not being powered on at this bespeak.
Once batteries are installed, the remote unit will transmit the wireless signal to the main unit about one time every minute. If the temperature does not display under the "OUT" on the main unit after a few minutes, refer to the troubleshooting section of this manual.

Placement:
The main unit may be wall mounted using the builtin hanger, or it tin can be placed on a desk or table using the foldout stand. The remote sensor tin can be wallmounted.
The remote unit is conditions resistant. Keep out of straight sunlight and direct weather elements to extend the life of the unit of measurement. Also, when selecting a location for the base unit of measurement, brand sure it is within 100 feet of the wireless remote sensor. The range may be afflicted past electronic interference from devices such as televisions and computers. For the best results, proceed both units at to the lowest degree 10 feet away from any electric equipment or devices that may crusade electronic interference.

Troubleshooting:
If the main unit of measurement displays "" in the "OUT" display area for more than than a few minutes:

• The batteries may be depression in the wireless remote sensor unit.
• The wireless remote sensor unit may exist out of range.
• Electronic devices or equipment may be causing interference relocate both units.
• Both units may need to exist reset to reestablish wireless communications.

If this problem persists, remove and replace the batteries on both units and place both units in close proximity to each other for awhile. This may help reestablish communications and avoid whatever electronic interference in the area.

Specifications:

• Temperature measurement range:
  • MAIN Unit of measurement: 32ºF 122ºF
  • WIRELESS REMOTE: 0ºF 130ºF

Battery Compartment Access (back)

Battery SAFETY:
Follow the polarity(+/-) diagram in the battery compartment. Promptly remove expressionless batteries from the device. Dispose of used batteries properly. Merely batteries of the same or equivalent type as recommended are to exist used. Practise Non incinerate used batteries. Do Non dispose of batteries in fire, as batteries may explode or leak. Exercise NOT mix erstwhile and new batteries or types of batteries (alkaline/standard).DO NOT apply rechargeable batteries. Practise Non recharge non-rechargeable batteries. DO Not brusque-circuit the supply terminals.

This device complies with Role 15 of the FCC Rules. Performance is subject to the following two conditions:

1. this device may not crusade harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
   Warning: Changes or modifications to this unit not expressly canonical past the party responsible for compliance could void the user'southward authorization to operate the equipment. Note: This equipment has been tested and constitute to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and tin can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may crusade harmful interference to radio communications.
   However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or tv reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
   • Reorient or relocate the receiving antenna.
   • Increase the separation between the equipment and receiver.
   • Connect the equipment into an outlet on a circuit different from that to which the receiver is continued.
   • Consult the dealer or an experienced radio/TV technician for assistance.

Practice not return product to retail store. For Technical Help and product return information,
delight call Chaney Instrument Co. directly at:
877-221-1252

Limited WARRANTY – INTERNATIONAL

Conswner may take more remedies at law than follows. Chaney Instrument Company warrants to the owner, this product to be complimentary from defect in material and workmanship

for one year from date of buy. CHANEY INSTRUM:ENT SHALL NOT Be LIABLE FOR ANY INCIDENTAL, INDIRECT OR CONSEQUENTIAL DAMAGES,

WHETHER ARISING IN CONTRACT OR TORT. Chaney Instrument's obligation (at its choice) is limited to repair or supercede this product. For in-warranty repair, send

clock, accompanied past Guarantee, begetting Dealer's name and appointment of buy, with $five.00 to cover handling and postage, to:

www.chaneyinstrument.com
Tel: 877-221-1252 Made in China
Chaney Instrument Visitor
965 Wells Street Lake Geneva, Wisconsin 53147

Documents / Resources

References

• AcuRite Weather Monitoring | #1 Weather Station Brand in North America

Source: https://manuals.plus/acurite/wireless-indooroutdoor-thermometer-manual

Share this post